172 Operation
Chapter 5 - Command Line Interface
5.9 SNMP Commands
Controls access to this AP from management stations using the Simple Network
Management Protocol (SNMP), as well as the hosts that will receive trap messages.

5.9.1 snmp-server community

This command defines the community access string for the Simple Network
Management Protocol. Use the no form to remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
•string - Community string that acts like a password and permits access to the SNMP protocol.
Table 5-10: SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit access to
SNMP commands
GC 172
snmp-server contact Sets the system contact string GC 173
snmp-server location Sets the system location string GC 173
snmp-server enable server Enables SNMP service and traps GC 174
snmp-server host Specifies the recipient of an SNMP notification operation GC 174
snmp-server trap Enables specific SNMP notifications GC 175
snmp-server engine id Sets the engine ID for SNMP v3 GC 176
snmp-server user Sets the name of the SNMP v3 user GC 17 7
snmp-server targets Configures SNMP v3 notification targets GC 178
snmp-server filter C onfigures SNMP v3 notification filters GC 178
snmp-server
filter-assignments
Assigns SNMP v3 notification filters to targets GC 179
show snmp groups Displays the pre-defined SNMP v3 groups Exec 180
show snmp users Displays SNMP v3 user settings Exec 180
show snmp
group-assignments
Displays the assignment of users to SNMP v3 groups Exec 181
show snmp target Displays the SNMP v3 notification targets Exec 181
show snmp filter Displays the SNMP v3 notification filters Exec 182
show snmp filter-assignments Displays the SNMP v3 notification filter assignments Exec 182
show snmp Displays the status of SNMP communications Exec 183