212 Operation
Chapter 5 - Command Line Interface
•100MH - Forces 100 Mbps, half-duplex operation
•100MF - Forces 100 Mbps, full-duplex operation
Default Setting
Auto-negotiation is enabled by default.
Command Mode
Interface Configuration (Ethernet)
Command Usage
If autonegotiation is disabled, the speed and duplex mode must be configured to match the setting
of the attached device.
Example

The following example configures the Ethernet port to 100 Mbps, full-duplex

operation.

5.17.6 shutdown

This command disables the Ethernet interface. To restart a disabled interface, use

the no form.

Syntax
shutdown
no shutdown
Default Setting
Interface enabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
This command allows you to disable the Ethernet port due to abnormal behavior (e.g., excessive
collisions), and reenable it after the problem has been resolved. You may also want to disable the
Ethernet port for security reasons.
Example

The following example disables the Ethernet port.

5.17.7 show interface ethernet

This command displays the status for the Ethernet interface.

Enterprise AP(if-ethernet)#speed-duplex 100mf
Enterprise AP(if-ethernet)#
Enterprise AP(if-ethernet)#shutdown
Enterprise AP(if-ethernet)#