Re-Connect to WAP 250G | AMX NXA-WAP250G guide

Appendix A: Troubleshooting

FIG. 43 TFTP Server Configuration dialog

Step 7: Re-Connect to WAP 250G

1.Open a web browser and enter the IP Address for the WAP250G.

2.Follow the Emergent Recovery System on-screen prompts to begin the Firmware upload.

NXA-WAP250G 802.11b/g Wireless Access Point	45

Image 49

AMX NXA-WAP250G manual Re-Connect to WAP 250G, Tftp Server Configuration dialog

Contents

NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Important Note FCC Radiation Exposure Statement Federal Communication Commission Interference Statement EC Conformance Declaration Overview Specifications Reset Button Power ConnectorEthernet Port Installation Straight-Through Wiring Access Point ConfigurationTwisted-Pair Cable Assignments Reset Button Overview Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsLED Indicators Hardware Description Symptom Action Power LED is Off Diagnosing Access Point Indicators Access Point Mode Selecting an Operation Mode Access Point Mode roaming for mobile users Access Point Mode Roaming Bridge Mode Access Point Mode Repeater and Bridge Mode Logging into the Web Interface Login Operation Mode Setting Using the Setup Wizard Setup Wizard Network Setting Network Setting Setup Wizard Network Setting PPoE settings Wireless VAP #1 Setting Dhcp Server/NAT Setting Setup Wizard Wireless VAP #1 Setting WEP settings Setup Wizard Wireless VAP #2 Setting Wireless VAP #2 Setting Setup Wizard Wizard configuration done Finish and RebootPage System Configuration Network Information System Information Information System Client Information Information Client Information Event Log Information Network System Setting Administration System Setting Operation Modes System Setting Vlan Status / Operation Mode System Settings Reset System System Setting VAP Management Wireless VAP Settings Basic Setting Wireless VAP Settings Wireless VAP 1 Setting Basic Settings Wireless VAP Settings Channel Setting Authentication Mode Select Open or Shared Wireless VAP Settings WEP Setting System Configuration WPA, WPA2, WPA-WPA2 Mix Mode Wireless VAP Settings WPA / WPA2 Setting Network Settings Dhcp Client Setting Network Settings Network Settings Dhcp Server/NAT Settings Network Settings Dhcp Server/NAT Setting Network Settings PPPoE Settings Network Settings PPPoE Setting Network Settings Radius Server Settings Network Settings Radius Server Setting Time and Log Time Setting Updating Firmware Upgrade via the Web Firmware Upgrade Local File Upgrade via a Remote Server System Configuration Page Choose Download site and Install Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenWebsite for free Tftp Server Copy Firmware file Change Tftp Server SettingsEthernet Connectivity Launch Tftp Server Re-Connect to WAP 250G Tftp Server Configuration dialogPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control