EC Conformance Declaration | AMX NXA-WAP250G instruction

Compliances

EC Conformance Declaration

Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). This equipment meets the following conformance standards:

EN 60950-1 (IEC 60950-1) - Product Safety

EN 300 328 - Technical requirements for 2.4 GHz radio equipment

EN 301 489-1, EN 301 489-17 - EMC requirements for radio equipment

This device is intended for use in the following European Community countries:

• Austria	• Belgium	• Denmark
• Finland	• France	• Germany
• Italy	• Luxembourg	• Netherlands
• Norway	• Spain	• Sweden
• Switzerland	• United Kingdom	• Portugal
• Greece	• Ireland	• Iceland

Requirements for indoor vs. outdoor operation, license requirements and allowed channels of operation apply in some countries as described below:

In Italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors.

In Belgium outdoor operation is only permitted using the 2.46 - 2.4835 GHz band: Channel 13.

In France outdoor operation is only permitted using the 2.4 - 2.454 GHz band: Channels 1 - 7.

2	NXA-WAP250G 802.11b/g Wireless Access Point

Image 6

AMX NXA-WAP250G manual EC Conformance Declaration

Contents

NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure Statement EC Conformance Declaration Specifications Overview Power Connector Reset ButtonEthernet Port Installation Access Point Configuration Straight-Through WiringTwisted-Pair Cable Assignments LED Indicators Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsReset Button Overview Hardware Description Diagnosing Access Point Indicators Symptom Action Power LED is Off Selecting an Operation Mode Access Point Mode Access Point Mode Roaming Access Point Mode roaming for mobile users Access Point Mode Repeater and Bridge Mode Bridge Mode Login Logging into the Web Interface Using the Setup Wizard Operation Mode Setting Network Setting Setup Wizard Network Setting Setup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 Setting Setup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 Setting Finish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information Network Information System System Information Information Client Client Information Information Network Information Event Log System Setting System Setting Administration System Setting Vlan Status / Operation Mode Operation Modes System Setting VAP Management System Settings Reset System Wireless VAP Settings Wireless VAP Settings Basic Setting Wireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic Settings Wireless VAP Settings WEP Setting Authentication Mode Select Open or Shared System Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix Mode Network Settings Network Settings Dhcp Client Setting Network Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT Settings Network Settings PPPoE Setting Network Settings PPPoE Settings Network Settings Radius Server Setting Network Settings Radius Server Settings Time Setting Time and Log Upgrade via the Web Updating Firmware Upgrade via a Remote Server Firmware Upgrade Local File System Configuration Page If Your WAP250G Is Stuck on the Emergent Recovery Screen Choose Download site and Install Tftp ServerWebsite for free Tftp Server Ethernet Connectivity Change Tftp Server SettingsCopy Firmware file Launch Tftp Server Tftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control