AMX NXA-WAP250G manual Using the Setup Wizard, Operation Mode Setting

Initial Configuration

Using the Setup Wizard

There are only a few basic steps you need to set up the NXA-WAP250G and provide a connection for your AMX Control Panel and network access for other wireless devices.

The Setup Wizard takes you through configuration procedures for the general network settings, such as IP configuration, wireless network name (Service Set Identifier), and wireless security. Follow these steps:

To begin, login and select Start with Setup Wizard on the home page (FIG. 5).

Step 1: Operation Mode Setting

Select an operation mode according to how the unit will be used in your network (FIG. 6).

FIG. 6 Setup Wizard - Operation Mode setting

There are two operation modes:

AP — Set the device as an Access Point. The device can also act as a root bridge in a wireless bridge network.

Repeater & Bridge — Set the device as a Wireless Repeater. The Root AP MAC Address can be assigned manually or selected after clicking Scan.

Reboot the NXA-WAP250G after completing the settings.

Click Next to proceed.

NXA-WAP250G 802.11b/g Wireless Access Point 13