AMX NXI-x000 Series manual Installation of Compact Flash Upgrades

Installation and Upgrading

Mounting

Brackets

Compact Flash

Compact Flash insert location

NXC Card Slot faceplate

FIG. 3 Location of the Compact Flash within a sample Integrated Controller

Chassis housing screws (top)

-6 on top

-sides vary per model

Chassis housing screws (side)

-4 on each side of the NI-4000

-3 on each side of the

NI-3000/2000

NXC Card Slots

3.Carefully pull-up and remove the housing up and away from the Controller to expose the internal circuit board (FIG. 3).

4.Refer to the followingInstallation of Compact Flash Upgradesfor detailed replacement information.

Installation of Compact Flash Upgrades

1.Discharge any static electricity from your body by touching a grounded metal object.

2.Locate the 32 MB Compact Flash card on the main board. For more detailed information on component locations, refer to FIG. 3.

3.Insert the tip of a grounded flathead screwdriver into one of the Card Removal Grooves (located on either side of the card), and gently pry the card out of the slot. Repeat this process on the opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board connector pins.

4.Slip your finger into the opening between the connector pins and the card, and push the card out to remove it.

5.Remove the upgrade card from it’s anti-static bag.

6.Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push it in firmly until the contact pins are completely inside the flash card and securely attached to the connector (FIG. 4).

18 NI-2000, NI-3000, NI-4000 Hardware Reference Guide