Connections and Wiring
configuration (Port 4) | configuration (Port 8) |
FIG. 6 RELAY connector (male) |
|
Input/Output (I/O) Port: Connections and Wiring
The I/O port responds to either switch closures, voltage level (high/low) changes, or it can be used for
configuration (Port 9) | configuration (Port 17) |
FIG. 7 INPUT/OUTPUT (I/O) connector (male)
A contact closure between the GND and an I/O port is detected as a Push.
When used for voltage inputs, the I/O port detects a low signal (0 - 1.5 VDC) as a Push, and a high signal (3.5 - 5 VDC) as a Release (this IO port uses 5V logic but can handle up to 12V without harm).
When used for outputs, the I/O port acts as a switch to GND and is rated for 200mA @ 12 VDC.
The
The
The PWR pin provides +12 VDC @ 200 mA and is designed as a power output for the PCS Power Current Sensors, VSS2 Video Sync Sensors (or equivalent).
The GND connector is a common ground and is shared by all I/O ports. A common ground is shared with I/O ports 1 - 8
I/O Port Wiring Specifications
NI-4000 and NI-3000
Pin | Signal | Function |
|
|
|
1 | GND | Signal GND |
|
|
|
2 | I/O 1 | Input/Output |
|
|
|
3 | I/O 2 | Input/Output |
|
|
|
4 | I/O 3 | Input/Output |
|
|
|
5 | I/O 4 | Input/Output |
|
|
|
6 | I/O 5 | Input/Output |
|
|
|
7 | I/O 6 | Input/Output |
|
|
|
8 | I/O 7 | Input/Output |
|
|
|
9 | I/O 8 | Input/Output |
|
|
|
10 | 12 VDC | PWR |
|
|
|
I/O Port Wiring Specifications NI-2000
Pin | Signal | Function |
|
|
|
1 | GND | Signal GND |
|
|
|
2 | I/O 1 | Input/Output |
|
|
|
3 | I/O 2 | Input/Output |
|
|
|
4 | I/O 3 | Input/Output |
|
|
|
5 | I/O 4 | Input/Output |
|
|
|
6 | 12 VDC | PWR |
|
|
|
29 | |
|
|
