Connections and Wiring
Connections and Wiring
Setting the Configuration DIP Switch (for the Program Port)
Prior to installing the Controller, use the Configuration DIP switch to set the baud rate used by the Program port for communication. The Configuration DIP switch is located on the front of the Integrated Controllers.
Baud Rate Settings
Before programming the
By default, the baud rate is set to 38,400 (bps).
Baud Rate Settings on the Configuration DIP Switch
Baud Rate | Position 5 | Position 6 | Position 7 | Position 8 | |
|
|
|
|
|
|
9600 bps | OFF | ON | OFF | ON | |
38,400 bps (default)
OFF
ON
ON
ON
57,600 bps
ON
OFF
OFF
OFF
115,200 bps
ON
ON
ON
ON
Note the orientation of the Configuration DIP Switch and the ON position label. DIP switches 2,3, and 4 must remain in the OFF position at all times.
Program Run Disable (PRD) Mode
You can also use the Program port’s Configuration DIP switch to set the
PRD Mode Settings
PRD Mode | Position 1 | |
|
|
|
Normal mode (default) | OFF | |
PRD Mode
ON
The PRD mode prevents the NetLinx program stored in the
If necessary, place the
21 | |
|
|
