Andrew manual ES45T-RReflector Assembly, Step Step Step, Installation Procedures

ES45T-R Reflector Assembly

Step 11

Step 12

Step 13

Remove small portion of foam padding from reflector packing crate and install under bottom portion of reflector assembly to prevent reflector damage during hoisting proce- dure. Position man at bottom of reflector/backstructure to guide assembly during hoist- ing procedure.

Hoist reflector/backstructure assembly to vertical position until upper joints of main trian- gle assembly contact pipe and straddle two locator bars on support and elevation assembly (P/N 49635) as shown in Figure 49.

Figure 49

Install two U-bolts at each pivot bracket of main triangle assembly.

•Use 1/2 inch (13 mm) lockwashers and nuts.

•Securely tighten U-bolts allowing for some reflector movement

41 Installation Procedures