Andrew ES45T manual Mechanical Parts Inspection Local Control/Motor, Drive Controller

Models: ES45T

1 81
Download 81 pages 35.94 Kb
Page 74
Image 74
Mechanical Parts

Mechanical Parts

Inspection

Local

Control/Motor

Drive Controller

scraper, stiff brush (bristle, or wire in the case of rust or corrosion), or cloth or com- pressed air at 25 to 40 psi. Any accumulated imbedded dirt, corrosion, grease or oil deposits that require further cleaning may be removed with a bristle or wire brush and a cleaning solvent such as trichlorethylene or equal. After cleaning, allow cleaned parts to dry for 10 to 15 minutes before placing the equipment into operation.

The frequency of inspection is contingent upon the user’s individual standards and the operational environment in which the earth station is located. However, a visual inspec- tion of the earth station components should be performed st least semi-annually. Where there are no established wear limits, perform a visual inspection to locate worn or dam- aged parts which could cause improper functioning of the earth station. It is recommend- ed that the mechanical and electrical inspection be performed on the assembled or par- tially disassembled equipment to determine the extent of disassembly required prior to completely disassembling a suspected malfunctioning component or module. In the absence of any special inspection requirements, operational tests are the most effective means in isolating parts and assemblies requiring further inspection. Any condition noted during inspection that may preclude continued proper operation of the earth sta- tion prior to the next scheduled inspection should be noted. The discrepant condition should be corrected (repaired or replaced) immediately or at the conclusion of the inspection procedure.

Inspection of the local control/motor drive controller conforms generally to standard visu- al inspection procedures on electromechanical equipment. In addition to these standard procedures, perform the following checks and visual inspections for the specific condi- tions noted:

WARNING

Care must be taken to avoid electrical shock. Failure to heed warning could result in injury or death.

Check the main panel for illegible and indistinct panel markings.

Connect the detachable hand controller assembly (local control) for visible signs of

damage such as cracked housing, damaged connector/bent pins, cuts or damage to cable jacket insulation, etc. Examine selector switches for damage and proper actuation movement.

Inspect all wiring and cables for discoloration and burned insulation, dirt, breaks,

security of connection and other signs of deterioration. Examine connections for dirt, flux, corrosion and mechanical defects. Check for loose or broken lacing and cut, brittle, abraded, frayed or cracked insulation.

Examine connectors for corrosion, broken inserts and stripped threads. Check con-

nector shells for distortion and dents, and contact pins for bends, misalignment or other deformities. Check connector inserts for carbon tracking indicating arc-over.

74

Preventive Maintenance

Page 74
Image 74
Andrew ES45T manual Mechanical Parts Inspection Local Control/Motor, Drive Controller, Preventive Maintenance