Andrew manual ES45T-T Reflector Assembly Step

ES45T-T Reflector Assembly

Step 9

Step 10

Step 11

Station an installer inside reflector to finger-tighten seam hardware and attach final pan- els as shown in Figure 59.

Figure 59

Loosely attach reflector segment B-Cto mounting ring hub and diameter setting bands. Use edge joining plate (P/N 49424) on B-Bpanel seam and joining plate (P/N 49693) on B-Brim seam.

Before attaching last panel, lift reflector and return temporary supports to initial measur- ing position. Have installer inside reflector check tension on diameter setting bands. If not uniformly taut, adjust level by adding shims until no segment of the reflector can bounce and bands are uniformly taut, as shown in Figure 60.

Figure 60

50 Installation Procedures