Theory of Operation

This Service Guide supports troubleshooting the Agilent Technologies 54835A/45A to assembly level. Theory of operation is included only as supplemental information. It is not comprehensive enough for component-level troubleshooting.

Block-Level Theory

The Agilent Technologies 54835A Oscilloscope has four channels which are individually sampled at 2 GSa/s. Each channel is stored into 32 Kbytes of memory. Pairs of channels can be combined to sample at 4 GSa/s and extend memory to 64 Kbytes.

The Agilent Technologies 54845A Oscilloscope has four channels which are individually sampled at 4 GSa/s. Each channel is stored into 32 Kbytes of memory. Pairs of channels can be combined to sample at 8 GSa/s and extend memory to 64 Kbytes.

The front panel provides:

Dedicated knobs and pushbuttons for major oscilloscope functions.

An 8.4-inch (diagonal) color flat panel display for waveform, measurement, and graphical interface display.

A 3 1/2-inch flexible disk drive.

BNC connectors for channel input signals, auxiliary trigger input, and auxiliary output.

AutoProbe interface for probe power and probe control.

A connection for probe compensation.

The rear panel provides several connections:

The line power input.

An GPIB connector, for connection to an instrument controller.

An RS-232 connection.

A parallel printer connection.

VGA monitor connection.

Mouse and keyboard connections.

The instrument has several assemblies and four attenuators. Use the instrument block diagram on the previous page for the following discussion.

Power Supply Assembly

The switching power supply provides 300 W maximum for the instrument. The ac input to the power supply is 100–240 Vac, +/-10%. Maximum input power is 390W. The ac input frequency is 47 to 440 Hz.

Filtered voltages of +5.1 V, –5.2 V, +12.2 V, and –12.2 V are supplied to the acquisition board, where they are distributed throughout the board and to other assemblies.

FPD Monitor Assembly

The monitor is a thin film liquid-crystal display (TFT-LCD). This FPD is an 8.4-inch diagonal, 640 by 480 pixel VGA Color Monitor. The assembly requires +3.3 V and +12 V from the power supply.

A twin fluorescent back light provides illumination for the LCD. The Backlight Inverter assembly converts the +12 V to +300-1000 volts (acrms) and drives the back light.

8–3

Page 196
Image 196
Agilent Technologies 46A, 45A, 54835A manual Block-Level Theory, Power Supply Assembly, FPD Monitor Assembly