Agilent Technologies 54835A To remove and replace the keyboard and flat-panel display assemblies

Chapter 6: Replacing Assemblies

To remove and replace the keyboard and flat-panel display assemblies

To remove and replace the keyboard and flat-panel display assemblies

Use these steps to disassemble and re-assemble the front panel assembly, including the keyboard and flat-panel display. Where necessary, refer to other removal procedures.

1Disconnect the power cable and remove the cover.

2 Remove the front panel assembly from the chassis.

3Remove the ten Torx T10 screws that secure the front panel cover plate to the front casting.

Figure 6-13

Front Panel Cover Plate Screws

4Carefully feed the front-panel keyboard cable W16 and the flat-panel display driver cable W20 through the cable access hole while separating the front panel cover plate from the front casting.

Keep Long Screws Separate for Re-assembly

The four screws that fasten the keyboard to the front panel plate are longer than those around the perimeter of the plate. Keep them separate for re-assembly.

5To remove the main keyboard, disconnect the cursor keyboard cable W15, pull off the knobs, and lift out the keyboard.

6–12