Agilent Technologies 54835A To remove and replace the power supply, Removing Power Supply Cables

Chapter 6: Replacing Assemblies

To remove and replace the power supply

	To remove and replace the power supply
	Use these steps to remove the power supply assembly. When necessary, refer to other removal
	procedures.
WARNING	SHOCK HAZARD!
	If the power supply is defective is could have a dangerous charge on some capacitors. This charge
	could remain for many days after removing power from the supply.

1Disconnect the power cable and remove the cover.

2Disconnect the cables W2, W3, and W4 from the front of the supply.

Two of these (W3 and W4) have retaining latches underneath. Press the latch to release the plug from the connector.

3Disconnect the line sync cable W6 from the rear of the supply.

4Remove the Torx T15 screw that secures the power supply ground wire to the chassis.

Figure 6-23

Removing Power Supply Cables

5Remove the two Torx T10 screws that secure the front of the supply to the chassis.

6Remove the two Torx T10 screws that secure the power supply to the back of the chassis.

7Lift the supply up and out of the chassis.

8To replace the supply, reverse the installation procedure. Ensure that the AC power connector is aligned with the cutout in the rear panel, that the supply chassis rests on the two tabs in the instrument chassis, and that the ground wire is routed through the notch at the rear of the power supply chassis.

Cable W2, which is the middle connector in front, connects to the pins toward the top of the supply.

To ensure electrical safety, you must reconnect the ground wire to the chassis.

6–24