Agilent Technologies 46A, 45A, 54835A To configure the motherboard jumpers and set up the BIOS

Chapter 5: Troubleshooting

To configure the motherboard jumpers and set up the BIOS

7Re-enter the WINBIOS to change one parameter that could not be set in step 6. a Press F1 to enter the BIOS Setup.

b Double-click on Detect IDE Utility. The line labeled “Pri. Master” should contain numeric information indicating that it has found a hard drive. Exit this utility.

If a hard drive was not found, check Motherboard Hard Drive Cable W9 and SVGA to Hard

Drive Cable W10. If the drive is still not found, replace the hard disk drive.

cExit the BIOS Setup and save the changes you made.

Table 5-8 summarizes the settings for the system configuration.

Table 5-8	Series 757 System BIOS Settings with 1.44 Mbyte floppy drive
	Configuration Item	Setting
	Load Optimal Defaults	YES
	Standard Setup—Date/Time	Enter current values
	Standard Setup—Floppy Drive A	1.44 MB, 3-1/2
	Standard Setup—Floppy Drive B	Not Installed
	Advanced Setup—System Keyboard	Absent
	PCI/PnP Setup—IRQ 9	ISA
	Peripheral Setup (OnBoard Primary/Secondary IDE)	Primary
	Detect IDE Utility (Hard drive Primary Master)	Data
	Power Management/APM*	Enabled
	Hard Disk Power Down Mode*	Suspend
	Hard Disk Time Out (minute)*	15 min

* These configurations are only for instruments with 64 Mb or more of RAM.

The oscilloscope should now reboot, load Windows 95, and come up with the scope display. If it does not, recheck your steps in the above procedure. If all the settings are correct, return to the Primary Troubleshooting Procedure.

5–41