Agilent Technologies 54835A, 45A, 46A manual To attach the optional trackball

Chapter 2: Preparing for Use

To attach the optional trackball

2While holding the latch in, slide the metal tabs up and to the rear of the oscilloscope until they fully engage the slot.

3Release the latch. The trackball baseplate should now be secure against the side of the oscilloscope.

4Snap the trackball assembly onto the pins of the baseplate. The trackball and buttons should face up and toward the front of the oscilloscope.

5Connect the 9-pin “D” connector on the trackball cable to the COM1 port on the back panel. Tighten the retaining screws.

For information on changing the trackball settings, see the User’s Quick Start Guide.

2–6