Agilent Technologies 46A, 45A, 54835A manual To remove and replace the hard disk drive

Chapter 6: Replacing Assemblies

To remove and replace the hard disk drive

To remove and replace the hard disk drive

Use theseg steps to remove and replace the hard disk drive. When necessary, refer to other removal procedures.

1Disconnect the power cable and remove the cover.

2Disconnect the hard disk interface cable W10 from the hard disk drive.

3Remove the 4 Torx T15 screws that secure the hard disk drive bracket to the chassis.

4 Remove the 4 Torx T10 screws that secure the HDD to the bracket.

CAUTION	DO NOT LET THE DISK DRIVE FALL!
	Support the drive while removing the screws so that the drive does not fall.

5Lift the hard disk out of the chassis. Store the disk in a safe place where it will not be bumped or dropped.

6To replace the hard disk drive, reverse the above procedure. Ensure that you reconnect the disk cable with the correct polarity.

CAUTION	DO NOT OVER TIGHTEN SCREWS!
	Do not overtighten the T10 screws that secure the HDD to the bracket. Torque to 3 in-lbs.

7Run the WINBIOS setup, discussed under “To configure the motherboard jumpers and set up the BIOS” in chapter 5.

Figure 6-20

Removing the Hard Disk Drive

6–20