APC 3000  Attach the Conduit Box bottom to the Enclosure, using 4 M4x13 screws

Electrical Installation – Input/Output Wiring – Single Mains (default)

Punch 2 holes in the marked areas of the Conduit Box bottom to fit the size of the conduit pipes.

Attach the Conduit Box bottom to the Enclosure, using (4) M4x13 screws.

Install conduit pipes in the Conduit Box.

Run cables through the conduit pipes and the bottom of the Conduit Box, guides cables up into the input/output area.

Install the top part of the Conduit Box to the Enclosure.

Neutral		N	N
Input		L1
cables		L2
		L3

Output			L2	Batt+
cables
		L1		N
				Batt—

Ground		L3
cables

Plate covering cable termination area



Attach input cable lugs on L1, L2 and L3 input busbars (left side in the UPS), using the provided M6 hex screws. Attach output cable lugs on L1, L2 and L3 output busbars, using the provided M6 hex screws. Attach N x 2 where shown, using the provided hex screws.

Attach Ground x 2 where shown, using the provided hex screws.

Reinstall the Plate, following reversed deinstallation procedures.

AIS® 3000 10-30kVA, 208V, Site Preparation and Installation Manual – 990-1957 33