Apollo 50, 55, 60, 65 twice, procedure, Active to Approach Transition, Set the desired inbound course with the, holding point and sequencing will again be

Approach Basics (GX50/60)

approach. You will now return to Approach Transition mode. The Approach Active light will go out and the CDI will gradually go back to Approach Transition CDI sensitivity (from 0.3 nm to 1.0 nm full-scale).

		As soon as you enable sequencing, the Apollo GX will
		sequence to the next waypoint in the flight plan. This
		is the next waypoint in the published missed approach
		procedure.
		If the next waypoint is the MAHP, it is an automatic
		holding point and sequencing will again be
		automatically suspended. The OBS/HOLD light will
		come back on. Operation will change from Approach
		Active to Approach Transition.
		3. Verify or select the next waypoint in your flight
	FPL
		plan. If the active waypoint is not the one you wish
		to navigate to, select a new active waypoint. If the
		active waypoint you want is already in your active
	D	flight plan, the easiest way to select it is to press
		FPL, to enter flight plan mode. Turn the SMALL
ENTER		knob until the waypoint you want is shown as the
		“TO” side of a flight plan leg . Then press
		DIRECT-TOand ENTER to select the waypoint.
		Note

D D

ENTER

If the same waypoint appears in the approach sequence more than once, be sure to turn to the occurrence you wish to select.

4.If a specific inbound course to the active waypoint is to be intercepted or flown, press DIRECT-TO twice.

5.Set the desired inbound course with the LARGE and SMALL knobs. If flying a holding pattern, press OBS/HLD. Then, press ENTER. Selecting an inbound course in this manner will suspend flight plan sequencing and the OBS/HLD annunciator will light. See page 24 for details on holding patterns.

9-14