Arkon PRT03831-xxx manual Er1

Section 10	91
Respond to Alarms, Errors, and Problems
Status Information (con’t)

	Status Information				Description
	CM Status.				Stores recent error codes related to the Continuous
					Monitoring mode (may be useful when calling Customer
		CM Status		08:30A	Care).
					Note: The CM Status screen shows information about
			Last Reset: OK
			Can’t Cal: 6		calibration and sensor errors. You can get information
			Cal Failed: BG High
					about why the system did not prompt you to perform a
			Sensor Err: 207
					calibration (“Can’t Cal: xxx”) or why a calibration failed (“Cal
			Back	Main	Failed: xxx”) or why continuous glucose readings are not
					displayed (“Sen Err: xxx”). These numbers and information
					help troubleshoot your system performance. The Customer
					Care representative may ask you to access the CM Status
					information.
	Calibration BG.				Allows you to add a new blood glucose reading used for
					calibration. Use this selection ONLY at the request of a
				08:30A	Customer Care representative.
					Note: Once you use this feature to successfully perform an
			Do You Want To		additional calibration, the system discards the parameters
					from the previous calibrations. It begins to calculate glucose
			Calibrate?
					results based on this calibration. When using the Calibration
			Yes	No	BG feature, always perform an additional Blood Glucose
					mode test to confirm the first test.
					This feature cannot be used in the first ten hours after sensor
					insertion. Using this feature does not change the regular
					scheduled times for calibration.
Alarms and Errors
			Display		Description
		Glucose CM		03:00A	The system will notify you of any conditions that may need
					your attention through messages that will be displayed on
		85mg/dL
					your receiver screen. You can find out what those messages
					mean and how to respond to them. For example, see Fig. 1.
					The messages are arranged alphabetically in the table titled
			Projected Low
			Glucose		“Respond to alarm message”.
			Acknowledge	Main
				Fig. 1
					When you use your built in FreeStyle Meter to make
					measurements, you may receive error codes on the receiver.
					You can find out how to respond when you get those codes.
					For example, see Fig. 2.
			Glucose BG	08:30
			Er1	Fig. 2

OVER