Asante Technologies 100TX user manual Configuring Network Access Parameters

Management

Configuring Network Access Parameters

To configure and/or manage an AsantéFAST 100 Hub stack over the net- work or via out-of-band access, the hub stack’s management module needs to be properly configured with network access parameters. These parameters are initially set-up in the management module via the module’s console port; however, some can be modified using IntraSpec- tion.

To configure network access parameters:

1 Do not select any item on the Device Page’s front panel image. (This selects the entire hub stack.)

2 Click Network.

The Network Information table appears, similar to Figure 3-9.

3

4

5

Figure 3-9 Network Information table

Click once in the field to be edited.

For a description of each field, see “Network “ on page 4-9.

▲Important: If you change the IP address, sub- net mask, and/or default gateway, you must reset the stack’s management module. See “Reset- ting a Group or Device” on page 3-20.

Type the new information.

Click Apply.

The network information is edited. Click Refresh to view updated information.

▲Important: If you changed the IP address, you must rediscover the device on your network map using the AutoDiscovery feature. See “Accessing the Device Page” on page 3-1 for instructions.

Page 3-10