12
Chapter 3: Hardware Installation and Setup
This chapter describes the procedures for
3.1 Installation Overview
1.Follow these steps to install the IntraCore IC3624PWR PoE switch:
2.Open the box and check the contents. For a complete list of the items included with the switch see “Equipment Checklist” section later in this chapter.
3.Install the switch in an equipment or wall rack, or prepare for desktop placement.
4.Connect the power cord to the switch and to an appropriate power source.
5.Connect network devices to the switch.
See the sections below for more detailed installation instructions.
3.2 Safety Recommendations
The following information provides safety guidelines to ensure general safety and to protect the switch from damage.
Note: The following guidelines may not include every possible hazard to which you may be exposed. Use caution when installing this switch. Only trained and qualified personnel install or replace this equipment.
•Keep the switch clean
•Keep tools and components off the floor and away from foot traffic
•Do not wear rings or chains (or other jewelry). Metal objects can heat up and cause serious injury to persons and damage to the equipment.
•Do not wear loose clothing. Fasten your tie or scarf and roll up your sleeves.
•When working with electricity, follow these guidelines:
•Disconnect all external cables before installing or removing the cover
•Do not work alone when working with electricity
•Always check that the cord has been disconnected from the outlet before performing hardware configuration
•Do not tamper with the equipment. Doing so could void the warranty
•Examine the work area for potential hazards (such as wet floors or ungrounded cables)
IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit
