Flash button, Program button | AT&T 8110, 8102 specs

Mute button

(On the 8110 only)

Message light

Dial pad

Handset jack

Speaker button (On the 8110 only)

Flash button

For turning off the microphone associated with the handset or the built-in speakerphone.

A red light that flashes when a message has been left for you.

The standard 12-button pad for dialing telephone numbers. The dial pad is also used with the PROGRAM button to store numbers on the Programmable Dialing buttons.

For connecting the handset to your telephone.

For accessing the built-in speakerphone and microphone combination.

For using features such as Conference with business communications systems, and for custom calling features if you are using your telephone at home.

Program button	For storing telephone numbers on the
	programmable dialing buttons on the front of
	your telephone.

The SIDE VIEW shows the following features:

Tone Selector (HI or LO)

Tone Selector (FAST or SLOW)

Ringer Volume control

For selecting one of 2 tone ringer frequencies (high or low).

For selecting one of 2 tone ringer modulation rates (fast or slow).

A3-position switch to control the volume for the tone ringer. Slide it up (away from you) for a louder ring, down (toward you) for a quieter ring. The volume control is

labeled

Ringer Vol

.

Speaker volume control For raising or lowering the volume of the

(On the 8110 only) built-in speakerphone. The volume control

is labeled Speakerphone Vol .

10

Image 13

AT&T 8110, 8102 user manual Flash button, Program button, Tone Selector Fast or Slow Ringer Volume control

Contents

AT&T Trademarks Contents Use Important Safety Instructions Service Emploi Consignes DE Securite Importantes Entretien Conservez CES Instructions Appendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 only Flash button Tone Selector Fast or Slow Ringer Volume controlProgram button Line jack Table/Desk Installation Installing Your Telephone Handset cord jack Handset jack Rotating the Handset Tab Wall Installation Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the Features Removing and Covering the Auto Answer Button Page Answering and Placing a Call Using the Features To end a call To place a call using the speakerphone for 8110 users Auto Answer for 8110 Users To turn off the Auto Answer featureTo have your telephone automatically answer a call Hold FlashTo put a call on hold To return to the held call Mute for 8110 Users Message Programmable Dialing Buttons Personalized Ring Programmable Dialing Buttons To dial a number with a programmable dialing button Redial With Auto-PauseTo erase a number stored on a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codes To place/answer a call without lifting the handset Speakerphone for 8110 UsersTo prevent other party from hearing you To mute microphone To change from speakerphone to handset Appendix a Page Answering Calls Appendix BOriginating Calls Putting Calls on Hold Switching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 Telephone If Your Telephone Does Not Respond Appendix D Connection and USE with the Nationwide Telephone Network FCC Registration and Repair Information Right of the Telephone Company Interference Information AT&T Warranty Information Dialing Numbers in Memory Storing Numbers in MemoryErasing a Number in Memory Holding and Returning to a Call Using the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March