Mounting studs Base | AT&T 8110, 8102 guide

Mounting studs

Base

FIGURE 7 Placing the Telephone on the Wall Jack Mounting Studs

6Plug one end of the line cord into the line jack on the bottom of the telephone. See Figure 8 for the location of the line jack.

Note: You may prefer to use an 8" line cord rather than the 7-foot cord provided with the telephone. If you use the 7-foot cord, you will need to place it into the back of the telephone in its original coiled position.

7Plug the free end of the line cord into the modular wall jack. See Figure 8.

Line jack

Modular jack

Line cord

TelephoneBase

FIGURE 8 Connecting the Line Cord to the Modular Jack and the Line Jack

16

Image 19

AT&T 8110, 8102 user manual Mounting studs Base

Contents

AT&T Trademarks Contents Use Important Safety Instructions Service Emploi Consignes DE Securite Importantes Entretien Conservez CES Instructions Appendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 only Flash button Tone Selector Fast or Slow Ringer Volume controlProgram button Line jack Table/Desk Installation Installing Your Telephone Handset cord jack Handset jack Rotating the Handset Tab Wall Installation Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the Features Removing and Covering the Auto Answer Button Page Answering and Placing a Call Using the Features To end a call To place a call using the speakerphone for 8110 users Auto Answer for 8110 Users To turn off the Auto Answer featureTo have your telephone automatically answer a call To return to the held call FlashHold To put a call on hold Mute for 8110 Users Message Programmable Dialing Buttons Personalized Ring Programmable Dialing Buttons To dial a number with a programmable dialing button Redial With Auto-PauseTo erase a number stored on a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codes To change from speakerphone to handset Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To prevent other party from hearing you To mute microphone Appendix a Page Putting Calls on Hold Appendix BAnswering Calls Originating Calls Switching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 Telephone If Your Telephone Does Not Respond Appendix D Connection and USE with the Nationwide Telephone Network FCC Registration and Repair Information Right of the Telephone Company Interference Information AT&T Warranty Information Holding and Returning to a Call Storing Numbers in MemoryDialing Numbers in Memory Erasing a Number in Memory Using the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March