Base Locking Tab Voice Terminal Wall | AT&T 8102, 8110 manual

8Plug one end of the coiled handset cord into the handset jack on the side of the telephone. See Figure 4.

9Place the telephone against the base and push down so that the base locking tab slides into the slot at the top of the telephone. See Figure 9.

10Push in on the triangle at the bottom center of the base to lock the bottom of the telephone into place. See Figure 9.

Base

Locking Tab

Voice Terminal

Wall

Base

Locking Tab

FIGURE 9 Connecting the Telephone to the Base

11Plug the free end of the coiled handset cord into the handset and hang up the handset. See Figure 4.

12Lift the handset and listen for dial tone.

17

Image 20

AT&T 8102, 8110 user manual Base Locking Tab Voice Terminal Wall

Contents

AT&T Trademarks Contents Important Safety Instructions Use Service Consignes DE Securite Importantes Emploi Conservez CES Instructions Entretien Your 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 only Program button Tone Selector Fast or Slow Ringer Volume controlFlash button Line jack Installing Your Telephone Table/Desk Installation Handset cord jack Handset jack Wall Installation Rotating the Handset Tab Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation Card Removing and Covering the Auto Answer Button Page Using the Features Answering and Placing a Call To place a call using the speakerphone for 8110 users To end a call To have your telephone automatically answer a call To turn off the Auto Answer featureAuto Answer for 8110 Users Flash HoldTo put a call on hold To return to the held call Message Mute for 8110 Users Personalized Ring Programmable Dialing Buttons Programmable Dialing Buttons To erase a number stored on a programmable dialing button Redial With Auto-PauseTo dial a number with a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbers Speakerphone for 8110 Users To place/answer a call without lifting the handsetTo prevent other party from hearing you To mute microphone To change from speakerphone to handset Appendix a Page Appendix B Answering CallsOriginating Calls Putting Calls on Hold Switching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix C Appendix D If Your Telephone Does Not Respond FCC Registration and Repair Information Connection and USE with the Nationwide Telephone Network Interference Information Right of the Telephone Company AT&T Warranty Information Storing Numbers in Memory Dialing Numbers in MemoryErasing a Number in Memory Holding and Returning to a Call Using the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March