Appendix a | AT&T 8102, 8110 guide

Appendix A

Adjunct Equipment Installation Instructions (For the 8102 Telephone Only)

Important: The installation of adjunct equipment (such as the AT&T S201A speakerphone or a 500A Headset Adapter) with the 8102 telephone is different from installation with other telephones.

Use the following procedure for connecting adjunct equipment to the 8102 telephone. (See Figure 12.)

Note: Although an S201A Speakerphone is shown in Figure 12, a 500A Headset Adapter is connected to the 8102 telephone in the same way.

1Plug one end of the adjunct cord into the adjunct equipment.

2Plug the other end of the adjunct cord into the Adjunct jack on the rear of the 8102 telephone.

3Plug one end of the adjunct power cord into the Adjunct Power jack on the bottom of the 8102 telephone.

4Plug the free end of the adjunct power cord into the adjunct power supply.

31

Image 34

AT&T 8102, 8110 user manual Appendix a

Contents

AT&T Trademarks Contents Important Safety Instructions Use Service Consignes DE Securite Importantes Emploi Conservez CES Instructions Entretien Your 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 only Flash button Tone Selector Fast or Slow Ringer Volume controlProgram button Line jack Installing Your Telephone Table/Desk Installation Handset cord jack Handset jack Wall Installation Rotating the Handset Tab Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation Card Removing and Covering the Auto Answer Button Page Using the Features Answering and Placing a Call To place a call using the speakerphone for 8110 users To end a call Auto Answer for 8110 Users To turn off the Auto Answer featureTo have your telephone automatically answer a call To put a call on hold FlashHold To return to the held call Message Mute for 8110 Users Personalized Ring Programmable Dialing Buttons Programmable Dialing Buttons To dial a number with a programmable dialing button Redial With Auto-PauseTo erase a number stored on a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbers To prevent other party from hearing you To mute microphone Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To change from speakerphone to handset Appendix a Page Originating Calls Appendix BAnswering Calls Putting Calls on Hold Switching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix C Appendix D If Your Telephone Does Not Respond FCC Registration and Repair Information Connection and USE with the Nationwide Telephone Network Interference Information Right of the Telephone Company AT&T Warranty Information Erasing a Number in Memory Storing Numbers in MemoryDialing Numbers in Memory Holding and Returning to a Call Using the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March