Using the Features, Answering and Placing a Call | AT&T 8102, 8110

Using the Features

The procedures which follow give short, step-by-step instructions for using each feature. For your convenience, features are listed alphabetically.

Note: At the end of this booklet is a one-page Quick Reference Guide which allows you quick access to procedures for many of the telephone features. You can remove this page from the manual (tear along the perforation), and keep it near your telephone.

Important: If your telephone does not respond to any button presses or if it sounds dead, refer to the procedures in Appendix D.

Using the Handset and Speakerphone

For most features you must lift the handset (go off-hook)before you can use a feature. However, if you are using an 8110 telephone, you may choose to leave your handset (on-hook,that is, leave the handset on the telephone cradle) and use your built-in speakerphone instead.

Note: The 8102 telephone has an Adjunct jack on the rear of the telephone so that you can use an externally added speakerphone, such as the AT&T S201A Speakerphone.

Answering and Placing a Call

To answer a call

1Pick up handset

2Speak to other party

To answer a call using the speakerphone (for 8110 users)

1When you hear the telephone ring, press [ Spkr ]

● Red light next to [ Spkr ] goes on

2Speak to other party

To place a call

1 Pick up handset

[dial tone]

2Dial desired number

21

Image 24

AT&T 8102, 8110 user manual Using the Features, Answering and Placing a Call

Contents

AT&T Trademarks Contents Important Safety Instructions Use Service Consignes DE Securite Importantes Emploi Conservez CES Instructions Entretien Your 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 only Tone Selector Fast or Slow Ringer Volume control Flash buttonProgram button Line jack Installing Your Telephone Table/Desk Installation Handset cord jack Handset jack Wall Installation Rotating the Handset Tab Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation Card Removing and Covering the Auto Answer Button Page Using the Features Answering and Placing a Call To place a call using the speakerphone for 8110 users To end a call To turn off the Auto Answer feature Auto Answer for 8110 UsersTo have your telephone automatically answer a call Flash HoldTo put a call on hold To return to the held call Message Mute for 8110 Users Personalized Ring Programmable Dialing Buttons Programmable Dialing Buttons Redial With Auto-Pause To dial a number with a programmable dialing buttonTo erase a number stored on a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbers Speakerphone for 8110 Users To place/answer a call without lifting the handsetTo prevent other party from hearing you To mute microphone To change from speakerphone to handset Appendix a Page Appendix B Answering CallsOriginating Calls Putting Calls on Hold Switching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix C Appendix D If Your Telephone Does Not Respond FCC Registration and Repair Information Connection and USE with the Nationwide Telephone Network Interference Information Right of the Telephone Company AT&T Warranty Information Storing Numbers in Memory Dialing Numbers in MemoryErasing a Number in Memory Holding and Returning to a Call Using the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March