Triangle | AT&T 8102, 8110 specs

2Turn the telephone upside down so that you can see the bottom of the telephone.

3Remove the mounting base by pushing in on the triangle at the center of the large end of the base and then lifting the base off the telephone. See Figure 6.

Triangle

FIGURE 6 Lifting the Base off the Telephone

4Turn the base so the larger end is down.

5Place the base on the wall-jack mounting studs and pull down until it is secure. See Figure 7.

15

Image 18

AT&T 8102, 8110 user manual Triangle

Contents

AT&T Trademarks Contents Important Safety Instructions Use Service Consignes DE Securite Importantes Emploi Conservez CES Instructions Entretien Your 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 only Tone Selector Fast or Slow Ringer Volume control Flash buttonProgram button Line jack Installing Your Telephone Table/Desk Installation Handset cord jack Handset jack Wall Installation Rotating the Handset Tab Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation Card Removing and Covering the Auto Answer Button Page Using the Features Answering and Placing a Call To place a call using the speakerphone for 8110 users To end a call To turn off the Auto Answer feature Auto Answer for 8110 UsersTo have your telephone automatically answer a call To put a call on hold FlashHold To return to the held call Message Mute for 8110 Users Personalized Ring Programmable Dialing Buttons Programmable Dialing Buttons Redial With Auto-Pause To dial a number with a programmable dialing buttonTo erase a number stored on a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbers To prevent other party from hearing you To mute microphone Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To change from speakerphone to handset Appendix a Page Originating Calls Appendix BAnswering Calls Putting Calls on Hold Switching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix C Appendix D If Your Telephone Does Not Respond FCC Registration and Repair Information Connection and USE with the Nationwide Telephone Network Interference Information Right of the Telephone Company AT&T Warranty Information Erasing a Number in Memory Storing Numbers in MemoryDialing Numbers in Memory Holding and Returning to a Call Using the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March