Installing Your Telephone, Table/Desk Installation | AT&T 8110

Installing Your Telephone

Note: Although the drawings in this section show an 8110 telephone, the following installation procedures are applicable for both the 8102 and the 8110 telephones.

Table/Desk Installation

Use the 7-foot straight line cord that came with your telephone to connect the telephone to a modular jack.

WARNING: Do not plug the handset cord into the line jack or the adjunct jack on the bottom of your telephone since it could damage your handset and the telephone.

1Turn the telephone upside down so that you can see the bottom of the telephone.

2Plug one end of the line cord into the line jack on the bottom of the telephone. See Figure 3 for the location of the line jack.

3Feed the line cord through the line cord routing channel. See Figure 3.

Line cord routing channel Line jack

BOTTOM VIEW

FIGURE 3 The Location of the Line Jack and Routing Channel

12

Image 15

AT&T 8110, 8102 user manual Installing Your Telephone, Table/Desk Installation

Contents

AT&T Trademarks Contents Use Important Safety Instructions Service Emploi Consignes DE Securite Importantes Entretien Conservez CES Instructions Appendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 only Tone Selector Fast or Slow Ringer Volume control Flash buttonProgram button Line jack Table/Desk Installation Installing Your Telephone Handset cord jack Handset jack Rotating the Handset Tab Wall Installation Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the Features Removing and Covering the Auto Answer Button Page Answering and Placing a Call Using the Features To end a call To place a call using the speakerphone for 8110 users To turn off the Auto Answer feature Auto Answer for 8110 UsersTo have your telephone automatically answer a call To return to the held call FlashHold To put a call on hold Mute for 8110 Users Message Programmable Dialing Buttons Personalized Ring Programmable Dialing Buttons Redial With Auto-Pause To dial a number with a programmable dialing buttonTo erase a number stored on a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codes To change from speakerphone to handset Speakerphone for 8110 UsersTo place/answer a call without lifting the handset To prevent other party from hearing you To mute microphone Appendix a Page Putting Calls on Hold Appendix BAnswering Calls Originating Calls Switching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 Telephone If Your Telephone Does Not Respond Appendix D Connection and USE with the Nationwide Telephone Network FCC Registration and Repair Information Right of the Telephone Company Interference Information AT&T Warranty Information Holding and Returning to a Call Storing Numbers in MemoryDialing Numbers in Memory Erasing a Number in Memory Using the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March