Wall Installation, Rotating the Handset Tab | AT&T 8110, 8102

Wall Installation

Use the following directions to mount the telephone on a standard wallphone jack with mounting studs.

1You must reverse the handset tab (which holds the handset when you hang up). See Figure 5.

●Hold down the switchhook and slide the tab up and out of its slot.

●Turn the tab so that the curved end is facing up.

●Insert the tab back into its slot.

b. Release and

remove handset

a. Handset retainerretainer. in place

c. Rotate handset	d. Replace handset
retainer 180 degrees.	retainer.

180°

FIGURE 5 Rotating the Handset Tab

14

Image 17

AT&T 8110, 8102 user manual Wall Installation, Rotating the Handset Tab

Contents

AT&T Trademarks Contents Use Important Safety Instructions Service Emploi Consignes DE Securite Importantes Entretien Conservez CES Instructions Appendix B Your 8102 and 8110 TelephonesPage TOP View 8110 Telephone Top, Side, and Bottom Views Auto Answer button On the 8110 only Handset Adjunct equipment jack On the 8102 only Program button Tone Selector Fast or Slow Ringer Volume controlFlash button Line jack Table/Desk Installation Installing Your Telephone Handset cord jack Handset jack Rotating the Handset Tab Wall Installation Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Labeling the Programmable Dialing Button Designation Card Using the Features Removing and Covering the Auto Answer Button Page Answering and Placing a Call Using the Features To end a call To place a call using the speakerphone for 8110 users To have your telephone automatically answer a call To turn off the Auto Answer featureAuto Answer for 8110 Users Hold FlashTo put a call on hold To return to the held call Mute for 8110 Users Message Programmable Dialing Buttons Personalized Ring Programmable Dialing Buttons To erase a number stored on a programmable dialing button Redial With Auto-PauseTo dial a number with a programmable dialing button To program an automatic pause for redialed numbers To erase ALL stored access codes To place/answer a call without lifting the handset Speakerphone for 8110 UsersTo prevent other party from hearing you To mute microphone To change from speakerphone to handset Appendix a Page Answering Calls Appendix BOriginating Calls Putting Calls on Hold Switching from the Headset to the Handset Appendix C Auxiliary Power for the 8110 Telephone If Your Telephone Does Not Respond Appendix D Connection and USE with the Nationwide Telephone Network FCC Registration and Repair Information Right of the Telephone Company Interference Information AT&T Warranty Information Dialing Numbers in Memory Storing Numbers in MemoryErasing a Number in Memory Holding and Returning to a Call Using the Auto Answer Feature For 8110 Users Only Using the Built-in Speakerphone For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March