Message, Mute for 8110 Users | AT&T 8102 specs

Hold (cont.)

or if you are using an 8110 telephone, you can return to the call by doing the following:

1Press [ Spkr ]

●Red light next to [ Spkr ] goes on; red light next to [ Hold ] goes off

●You are connected to other party

Message

This feature can be used only if your telephone is connected to a business communications system such as System 25 or 75. Your Message light flashes to let you know that a caller has left a message for you. You can then follow your System Administrator’s local message retrieval procedures to get your message.

Note: The Message light also flashes when a call is coming in (that is, when the telephone is ringing).

Mute (for 8110 Users)

Turns off the microphone of the built-in speakerphone or the handset. Use when you want to confer with someone in the room with you, but you do not want the other party on the call to hear your conversation.

To prevent the other party from hearing you (To mute microphone)

1Press [ Mute ]

●Red light next to [ Mute ] goes on

●Other party cannot hear you

To resume talking to the other party (To turn on microphone again)

1Press [ Mute ]

● Red light next to [ Mute ] goes off

2Resume conversation with other party

25

Image 28

AT&T 8102 user manual Message, Mute for 8110 Users

Contents

AT&T Trademarks Contents Important Safety Instructions Use Service Consignes DE Securite Importantes Emploi Conservez CES Instructions Entretien Your 8102 and 8110 Telephones Appendix BPage TOP View 8110 Telephone Top, Side, and Bottom Views Handset Adjunct equipment jack On the 8102 only Auto Answer button On the 8110 only Flash button Tone Selector Fast or Slow Ringer Volume controlProgram button Line jack Installing Your Telephone Table/Desk Installation Handset cord jack Handset jack Wall Installation Rotating the Handset Tab Triangle Mounting studs Base Base Locking Tab Voice Terminal Wall Using the Features Labeling the Programmable Dialing Button Designation Card Removing and Covering the Auto Answer Button Page Using the Features Answering and Placing a Call To place a call using the speakerphone for 8110 users To end a call Auto Answer for 8110 Users To turn off the Auto Answer featureTo have your telephone automatically answer a call Flash HoldTo put a call on hold To return to the held call Message Mute for 8110 Users Personalized Ring Programmable Dialing Buttons Programmable Dialing Buttons To dial a number with a programmable dialing button Redial With Auto-PauseTo erase a number stored on a programmable dialing button To erase ALL stored access codes To program an automatic pause for redialed numbers Speakerphone for 8110 Users To place/answer a call without lifting the handsetTo prevent other party from hearing you To mute microphone To change from speakerphone to handset Appendix a Page Appendix B Answering CallsOriginating Calls Putting Calls on Hold Switching from the Headset to the Handset Auxiliary Power for the 8110 Telephone Appendix C Appendix D If Your Telephone Does Not Respond FCC Registration and Repair Information Connection and USE with the Nationwide Telephone Network Interference Information Right of the Telephone Company AT&T Warranty Information Storing Numbers in Memory Dialing Numbers in MemoryErasing a Number in Memory Holding and Returning to a Call Using the Built-in Speakerphone For 8110 Users Only Using the Auto Answer Feature For 8110 Users Only Comcode 555-015-131 Graphics AT&T Issue 2, March