INSTALLATION

Table/Desk Installation

continued from page 11

2Connect the handset cord.

Plug one end of the coiled handset cord into the jack on the left side of the phone. Plug the other end into the handset and hang up.

3Connect the power adapter to the telephone.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 222–3111.

Plug one end of the power adapter into the jack labeled POWER on the back of the phone. Plug the other end into a standard electrical outlet not controlled by a wall switch.

Standard

Electrical

Outlet

POWER jack

Power adapter

4Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY beginning on page 87.

5Initialization.

If no battery is installed when you connect the power cord, the phone runs a quick self-test and the screen displays Initializing.. for about three seconds.

NOTE: The phone will run through this same initialization any time it is reconnected to AC power if a charged battery is not installed (for example, after a power failure or when the unit has been unplugged).

12

Page 16
Image 16
AT&T 945 Table/Desk Installation, Connect the handset cord, Connect the power adapter to the telephone, Initialization