AT&T 945 user manual Before YOU Begin, Parts List, Tools Needed

BEFORE YOU BEGIN

Parts List

Your box should include:

BEGIN

USER’S MANUAL

Part 2

Four-Line Intercom

Speakerphone 945

This User’s Manual

This Quick Start Guide provides basic instructions. For addtional installation options and complete instructions which allow you to use all features of this phone, refer to your User's Manual.

INSTALLATION

Installation of a DSL splitter and an AT&T Z800A filter is required to use the advanced features of this telephone if you have DSL (Digital Subscriber Line) service. Please see “DSL Users” starting on page 4 of your User’s Manual for details.

If you are installing multiple phones in your phone

QUICK START GUIDE

Four-Line Intercom

Speakerphone 945

Table/Desk Installation

For best results, follow the directions in “Battery Installation” above, before installing the phone.

1 Connect the telephone line cords to the telephone as shown in the appropriate illustration below.

• Four One-Line Jacks (To use this installation option, you’ll need to purchase two two-line adapters. Adapters are available at retail stores or by calling 1 800 222–3111.)

ModularModular telephone jacks

system, you must install and program one set at a time. Each phone must be assigned a unique extension

Lines 3 and 4

telephone jacks Lines 1 and 2

Please also read

Part 1 — Important

Product Information

© 2004 Advanced American Telephones. All Rights Reserved.

AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American Telephones.

number.

Battery Installation

Install a 9V alkaline battery (purchased separately) in order to use some features of this telephone in the event of a power failure.

1Remove the wedge from the underside of the base unit. Press on the tabs and pull the wedge away from the phone.

2Remove the battery compartment screw with a small Phillips head screwdriver.

3Pull on the tab to remove the battery compartment cover.

4Insert a 9V battery (purchased separately) following the polarity diagram inside the battery compartment.

5Replace the battery compartment cover and the screw.

6Reattach the wedge to the base unit by sliding the tabs into the holes. Snap the wedge onto the base.

Two-line adapters

Telephone line cords

L3/L4 jack L1/L2 jack

•Two Two-Line Jacks

Modular	Modular telephone
telephone jack	jack Lines 1 and 2
Lines 3 and 4
	Telephone
	line cords

L3/L4 jack L1/L2 jack

2Connect the handset cord.

Plug one end of the coiled handset cord into the jack on the left side of the phone. Plug the other end into the handset and hang up.

Two seven-foot line cords

Handset

Eight-inch line cord

Base Unit

Coiled handset cord

Power adapter

Tools Needed

You will also need a small Phillips head screw driver to install your phone.

2