The Test Button
Section 4 The Test Button
The test button is located on the front right hand side of the AXIS 540+/AXIS
560 and is used for:
•Printing a test page to check the connection to the printer.
•Printing a parameter list to see the print server’s current settings.
•Performing a Factory Default of the print server.
If you want to change any of the parameters, use one of the methods described in Management and Configuration, on page 79.
Printing a Test Page Press the test button once to print a test page. The test page contains basic information about the AXIS 540+/AXIS 560. It is recommended that you print a test page every time you connect the print server to a printer.
Printing the Press the test button twice to print a parameter list showing the current AXIS Parameter List 540+/AXIS 560 settings. This list provides comprehensive details of all the
parameters and their current status. Refer to Section 17 The Parameter List, on page 1.
Performing a Factory Default
1.Remove the external power supply to switch off the print server.
2.Press and hold down the test button, while you reconnect the external power supply.
3.Continue to hold down the test button until the network indicator remains constantly lit. This should take about 20 seconds.
4.Restart the print server by disconnecting and reconnecting the external power supply.
For print servers with firmware version 6.43 and higher, a Factory Default will reset all AXIS 540+/AXIS 560 parameters and settings to their default values, except:
•Installed certificate •Private key
AXIS 540+/AXIS 560 | 103 |
