Axis Communications 540+, 560 user manual Management and Configuration

Management and Configuration

The Serial Printer Port HP JetAdmin does not support serial printer ports. If you must change the default settings of the serial printer port of the print server, it is recommended that you use the AXIS NetPilot. This will become necessary when you are installing a printer on your serial port. Follow the steps below to change the serial port parameters using AXIS NetPilot.

1.Start the AXIS NetPilot.

2.Select your Axis Network Print Server and click Install on the AXIS NetPilot toolbar. Select with current configuration.

3.Your Axis Network Print Server has been transferred to the ‘Network Print Servers’ folder. Select your Axis Network Print Server and click the Property button on the AXIS NetPilot toolbar.

4.Select the Printer Ports tab.

5.Select COM1 from the Printer Port drop-down list.

6.Select XON/XOFF from the Handshake Protocol drop-down list, set the Baud Rate to 38400 and select 1 stop bit. Click OK.

The settings in step 6 varies between different printer models. Please refer to your printer documentation.

If your network supports TCP/IP you can also change the serial port parameters by using the Axis Network Print Server Web interface.

92 AXIS 540+/AXIS 560