2.Group ID: There are three trunk groups available to configure. Choose the ‘Group ID’ and click Select 
.
3.LACP: If enabled, the group is an LACP static trunk group. If disabled, the group is local static trunk group. All ports support LACP dynamic trunk. If connected to a device that also supports LACP, the LACP dynamic trunk group is automatically created.
4.Work ports: A maximum of four ports can be aggregated at the same time. With LACP static trunk group, any excess ports are considered standby and can be aggregated if a work port fails. If it is local static trunk group, the number of ports must be the same as the group member ports.
5. Select the ports add to the trunk group. Click Add 
button to add the
port. To remove unwanted ports, select the port and click
Remove 
button.
6.When LACP is enabled, you can configure LACP Active/Passive status for each port on the State Activity page.
7.Click Apply 
.
8. Use Delete 
button to delete Trunk Group.
62 | Manual Documentation Number: |
| |
| B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph |
| B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 |
