BENDIX BW2849 manual Code 22 SID 8, FMI 2 Left Turn Signal, Step a

Fault Isolation Procedures

Code 22 (SID 8, FMI 2) Left Turn Signal

Step A	Procedure	Condition	Action
1.	Key off.
2.	Is the vehicle equipped	If equipped with a Left	Go to Step B.
	with a Left Side Sensor?	Side Sensor
		If not equipped with a	The Central Processing Unit
		Left Side Sensor	has been programmed for a
			Left Side Sensor. With a
			PC-based or Hand-held
			Diagnostic Tool, place the

Left Side Sensor option in “NO” position. Go to Step V.

Step B Procedure Condition Action

1.Key off.

2.Disconnect the 32-way Central Processing Unit connector.

3.Key on.

4. Measure voltage between	If voltage is below .5 volts	Go to Step C.
Central Processing Unit
32-way connector pin D15
and C2.
Note: Do not short pins while	If voltage is outside of range	Repair OEM wiring harness
performing measurement.		as required. Go to Step V.

D	C
	1	VOLT
	2
	3
	4
	5	COM	A
	V
	6
	7
	8
	9
	10
	11
	12
	13
	14
	15
	16

(SID 8, FMI	Code 22
2)

2-54