BENDIX BW2849 Code 23 SID 3, FMI 2 Brake Input Error, Go to Step B If the brake lights are not

Fault Isolation Procedures

Code 23 (SID 3, FMI 2) Brake Input Error

Step A Procedure Condition Action

1.Key off.

2.Verify the vehicle brake lights are working correctly.

If the brake lights are working correctly

Go to Step B.

If the brake lights are not	Repair vehicle brake lights.
working correctly	Go to Step V.

(SID 3, FMI	Code 23
2)

Step B	Procedure	Condition	Action
	1. Using a PC-based or Hand-held	If configuration is set to Discrete	Go to Step C.
	Diagnostic Tool verify vehicle
	brake configuration.

If vehicle uses J-1939 or J-1587 configuration

Repair OEM wiring harness J-1587 or J-1939 data link may not be connected to the VORAD system. Go to Step V.

If vehicle uses LED brake lights	Contact a Bendix representative for
	proper configuration.

Note: VORAD must use either J-1939 or J-1587 to receive brake signal when LED tail lights are used on a vehicle.

2-58