Chapter 3: Installation
1 | 2 | 3 | 2 | 4 |
Figure
Table
Number Description
1Video sources, for example, an SDI camera
2Interconnect cable
3ServSwitch DKM FX
4Video sinks, for example, a monitor
3.2.3Parallel Operation (Stacking)
If you have special configurations, especially at installations with several monitors per workstation, or you need additional support for USB 2.0 transmission paths, you can increase the number of CPUs and consoles connected using a parallel operation (stacking) of several ServSwitch DKM FX devices.
One of the ServSwitch DKM FX matrices has to be defined as the master ServSwitch DKM FX, and all the others have to be configured as slaves (see Section 4.4.1) and must be connected to the master ServSwitch DKM FX via a network.
If you send a switching command via the OSD, the slave matrices will also switch.
NOTE: Switching of stacked devices might be delayed by several seconds.
Page 42 |