Body Solid G2B manual Two 81 5/16 x 5/8 allen screw Two 82 5/16 washer

S T E P

8

Be careful to assemble all components in the sequence they are presented.

A.Attach Leg Extension Frame (H) and Flat Plate (J) to Angled Vertical Frame (D) using:

Two 55 (3/8” x 3” hex head bolt) Four 70 (3/8” washer)

Two 67 (3/8” nylon lock nut)

Leg Extension Frame (H) is pre-assembled with Seat Pad Frame (K).

B.Attach Leg Extension Frame (H) to Main Base Frame (A) using:

One 56 (3/8” x 4 1/2” hex head bolt) Two 70 (3/8” washer)

One 67 (3/8” nylon lock nut)

C.Insert End Cap (16) to Leg Extension Frame (H). Insert Flat End Cap (8) to Seat Pad Frame (K).

Insert End Cap (16) to the back of Seat Pad Frame (K) as shown.

D.Attach Leg Extension Arm (L) to Leg Extension Frame (H) using Shaft (80) and the pre-installed hardware:

Two 81 (5/16” x 5/8” allen screw) Two 82 (5/16” washer)

Tighten Allen Screws (85).

Insert End Cap (17) into the top of Leg Extension Arm (L) as shown.

E.Slide Roller Bar (AF) into the front of Seat Pad Frame (K). Slide two Nylon Washer (21) onto the Roller Bar (AF).

Slide two Rollers (30) onto the Roller Bar (AF) and hold in place with Roller End Cap (10).

F.Slide Roller Bar (AF) into the opening in Leg Extension Arm (L).

Slide two Rollers (30) onto the Roller Bar (AF) and hold in place with Roller End Cap (10).

G.Attach Seat Pad (BA) to Seat Pad Frame (K) using:

Two 59 (5/16” x 1 3/4” hex head bolt)* Two 72 (5/16” spring lock washer)

Two 73 (5/16” washer)

*Do NOT over-tighten pad bolts (59). Tighten these bolts untill spring lock washer is flat. Over - tightening these bolts will cause T - nuts in pads to strip out.

Note:

You should now wrench tighten all bolts and nuts in this step.

Do NOT re-tighten any of the pad bolts or pulley bolts.

mm

Inch

24