S T E P
15
Be careful to assemble all components in the sequence they are presented.
NOW IS THE TIME TO MAKE ALL NECESSARY
CABLE ADJUSTMENTS
After cable installation is complete you must check all cables for proper tension. Obvious signs that cable
tension χproblems exist include:
Top Plate (29) does not rest directly on the top weight stack plate.
χ The holes in the Selector Rod (19) does not line up with the holes in the Weight Stack Plates. χ Cable(s) are sloppy and there is no resistance from the weight stack for the first few inches of
the exercise.
There are FIVE areas for cable adjustment on the G2B:
A. Selector Rod Top Bolt (103).
B. Two Rubber Stops (113).
C. Two Adjustments in Double Pulley Holder (CA).
SEE NOTE 1 ON PAGE 39.
If there is too much tension, and the Top Plate (29) is not resting directly on the top weight stack plate: 1st.- Turn and tighten the Rubber Stop (113).
2nd.- Move pulley (A7) up to a higher hole in Double Pulley Holder (CA). 3rd.- Move pulley (B3) down to a lower hole in Double Pulley Holder (CA).
If there is to much play or excessive slack:
1st.- Turn and loosen the Rubber Stop (113).
2nd.- Move Pulley (A7) down to a lower hole in Double Pulley Holder (CA). 3rd.- Move Pulley (B3) up to a higher hole in Double Pulley Holder (CA).
4th.- Screw the Selector Rod Top Bolt (103) farther into the Selector Rod (19) of the Weight Stack.
NOTE:
Cables should be inspected daily and adjusted periodically to ensure safe and smooth operation.
NOTE:
After cable adjustment is complete, go back and tighten all bolts. Make sure to tighten the two bolts in Double Pulley Holder (CA).
mm
Inch
38
