Assembly
Attaching Rip Fence
1.Raise rip fence handle 1, so holding clamp 2 is out far enough to fit on the table 3 and into “V” groove located on the back of rear rail (Fig. 14).
2.Position the rip fence 4 over table 3 holding up the front end, first engage holding clamp 2 with rear rail.
3.Lower front end onto front rail 5.
Mounting The
Table Saw
If table saw is to be used in a permanent location, it should be fastened securely to a firm supporting surface such as a stand or workbench, using the four mounting holes 6 (Fig. 15).
1.If mounting to a workbench, the base should be bolted securely using 5/16" hex bolts (not included) through mounting holes 6.
Hint: If workbench is 3/4” thick, bolts will have to be at least
2.Locate and mark where the saw is to be mounted, relative to holes in the base of the tool.
3.Drill four (4) 3/8" diameter holes through workbench.
4.Place table saw on workbench aligning holes in base with holes drilled in workbench.
5.Insert four (4) 5/16" dia. bolts through holes in base and supporting surface; then secure with (4) 5/16” flat washers and
(4) 5/16" hex nuts.
| 4 | |
FIG. 14 | ||
|
|
|
2 | 1 | |
2 | ||
|
1
3
3
5
FIG. 15
6
32.
