60.
Pre-Cut Locator
Allows you to mark and locate exactly where the blade will enter
the workpiece.
Always make sure table saw is turned off and unplugged.
Set blade 1at 90 degrees square to table. Using a straight edge
and a soft pencil, place straight edge 2 against both sides of
blade and mark lines on locator 3 (Fig. 47). These lines indicate
the “path” of the cut (kerf) made by the blade.
When cutting the workpiece, line up mark on workpiece with the
line on the disc (Fig. 48).
90
30
45
60
75
75
60
45
30
FIG. 47
FIG. 48
Using The Rip Fence PointerWhen Table Is Not Extended
The rip fence pointer shows the distance from the blade to rip fence
through a convenient viewing and magnifying window.
Align rip fence pointer 4with lower portion of scale 5. The lower
scale can be used for widths up to 13.5 inches (Fig. 49).
Using The Table Pointer When Table Is Extended
The upper portion of scale 6is used for rip cut 13.5 to 25 inches.
Align table pointer 7 with upper portion of scale 6 (Fig. 49).
Making Rip Cuts Beyond 25Inches Without The Use Of Scale
When positioning fence for maximum rip without the use of scale,
loosen screw 8and lower plate 9below the head 10 of the rip
fence 11 (Fig. 49). DO NOT rip or cut dados or moldings with the
fence beyond this position because it cannot be locked.
FIG. 49
1
3
2
4
5
67
8
9
10
11