D9412GV3/D7412GV3 Operation and Installation Guide | 3.0 | Overview |
|
|
|
3.3Features in the D9412GV3 and D7412GV3
3.3.1SDI Molex Connector
Use the SDI Molex Connector to easily connect an SDI device to the SDI bus without needing to disconnect wires connected to the SDI terminals. Possible applications include:
∙Connecting a DX4010i to program the control panel with Remote Programming Software (RPS) at the premises
∙Connecting a keypad to test the control panel.
Do not connect the D5200 Programmer to the SDI Molex connector.
Control panel firmware v8.11 or later does not support the D5200.
UL requires that the DX4010i be used for programming only.
3.3.2Tip and Ring Posts
The tip and ring posts allow connecting a phone or buttset for the purpose of troubleshooting communications between the control panel and the central station. This connection allows monitoring of the dial tone, handshaking tones from the receiver, and communications signals.
3.3.3Telephone Line Sniff
The D9412GV3 and D7412GV3 control panels monitor the phone line for the programmed supervision interval before indicating a phone line trouble.).
3.3.4Points
The Bosch Security Systems, Inc. D9412GV3 Control Panel provides up to 246 points of protection. The D7412GV3 Control Panel provides up to 75 points of protection. Point programming parameters determine the control panel’s response to open and shorted conditions on the sensor loop for the point. Several options allow individual point programming to custom- fit the protection to the installation.
Points 1 to 8 are located on the circuit board (on- board points). They are standard sensor loops. The remaining
Any points programmed as fire supervisory points are latching.
3.3.5Areas and Accounts
The D9412GV3 supports up to 32 areas. The D7412GV3 supports up to 8 areas. You can assign all points to a single area or distribute them over all supported areas.
The control panel is armed and disarmed by area, and several areas can be armed and disarmed with one menu function. A passcode can also be assigned an authority level that allows a user to arm an area from a remote keypad in another area.Assigning each area its own account number creates up to 32 separate accounts in the D9412GV3, and up to 8 separate accounts in the D7412GV3. Assigning the same account number to different areas groups them together in a single account.
Area options include exit tone and delay, separate fire and burglary outputs, and multiple opening and closing windows. Area type can be used to create area interdependencies for arming purposes.
3.3.6Digital Communicator
The control panel uses a
The control panel connects to an RJ31X or RJ38X jack for telephone line seizure. Connecting to the RJ31X complies with FCC regulations for using the public telephone network. The control panel can be programmed to direct reports to four separate telephone numbers. Adding the D928 Dual Phone Line Switcher Module allows connecting and supervising a second telephone line.
The system can route groups of Event Reports to four different destinations. Each report group can be programmed to send reports to one or more destinations. Primary and backup reporting paths can be programmed for each destination and each report group. A custom option allows specification of individual Event Reports to be sent.
Bosch Security Systems, Inc. 10/10 | 12 |
