VIP X2 Installation and Operating Manual | EN 131 |
|
|
–Enter 1 again. The terminal program displays the current IP address and prompts you to enter a new IP address.
–Enter the desired IP address and press Enter. The terminal program displays the new IP address.
–Use the displayed commands for any additional settings which you require.
Note
You must restart to activate the new IP address, a new subnet mask or a gateway address.
Restart
Briefly interrupt the power supply to the VIP X2 for a restart (disconnect the power supply unit from the mains supply and switch on again after a few sec- onds).
Additional parameters
You can use the terminal program to check other basic parameters and modify them where necessary. Use the
Bosch Security Systems | Appendix |