EN 20

Installation and Operating Manual VIP X2

 

 

Connections

Cameras

You can connect two video sources to the VIP X2. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable.

–Connect the cameras or other video sources with a video cable (75 Ohm, BNC connector) to the BNC Video In 1 and Video In 2 sockets.

–If the video signal is not looped through, termination is performed by a soft- ware setting if necessary (see Video input, page 46).

Audio connections (audio version only)

The audio version of the VIP X2 has two audio ports for audio line signals as well as a microphone input and a loudspeaker output.

The audio signals are transmitted two-way and in sync with the video signals. As a result, you can connect a speaker or door intercom system at the destination point, for example.

Note

If possible you should use the line ports of the intercom for transmitting audio signals on the intercom systems. The following specifications should be complied with in all cases.

Line In:

Impedance 9 kOhm typ., 5.5 Vp-pmax. input voltage

Line Out:

Impedance 16 Ohm min., 3 Vp-pmax. output voltage

MIC (microphone):

Impedance 2 kOhm typ., 2.8 Vp-pmax. input voltage,

 

–20 dB in, supply 2.3 V typ.

SPK (speaker):

Impedance 4 Ohm min., 6 Vp-pmax. output voltage,

 

power output RMS 1 W

Installation

Bosch Security Systems 2006-12 V2.5