Brady 200M, 260M manual Media

M-Series User ’s GuideIntroduction

Media

Media Specifications			200M		260M
Total media width		Maximum	4.5"	115 mm	7.2"	182.9 mm
		Minimum	0.75"	19 mm	2.0"	50.8 mm
Label	Maximum		Refer to “ Printing Considerations” on page 1-6.
length
	Minimum	Tear-Off	0.5"	12.8 mm	0.63"	16.00 mm
		Peel-Off	0.5"	12.8 mm	0.75"	19.05 mm
		Rewind	0.5"	12.8 mm	0.75"	19.05 mm
Total	Maximum (Printhead		0.012"	0.304 mm	0.012"	0.304 mm
thickness	position may need to be
(includes	adjusted above 0.01")
liner)
	Minimum		0.0023"	0.058 mm	0.0023"	0.058 mm
Core size			3.0"	75 mm	3.0"	75 mm
Maximum roll diameter			8.0"	203 mm	8.0"	203 mm
Interlabel gap			0.079" - 0.157"	2 - 4 mm	0.079" -	2 - 4 mm
(0.115"/3 mm preferred)					0.157"
Maximum internal fanfold media pack			8.0" x 4.5" x	203 x 105 x	8.00" x	203 x 183 x
size (L x W x H)			6.2"	158 mm	7.2" x 6.2"	158 mm
Additional Specifications for Black-Mark Media*
Mark thickness		Minimum	0.12"	3 mm	0.12"	3 mm
(measuring parallel to
		Maximum	0.43"	11 mm	0.43"	11 mm
label/tag edge)
Mark width (measuring		Minimum	0.43"	11 mm	0.43"	11 mm
perpendicular to
		Maximum	Full media width.		Full media width.
label/tag edge)
Mark-to-mark leading edge registration			+ /- 0.016"	+/- 0.4 mm	+/- 0.016"	+/- 0.4 mm
tolerance
Mark location			Mark is recommended to be		Marks must be located on
			located on the inside of the media		the inside of the media
			(closest to the printer’s mainframe		(closest to the printer’s
			when loaded in the printer). If		mainframe when loaded in
			mark is located elsewhere, test for		the printer).
			your application.
Mark density			> 1.0 ODU (Optical Density Unit)
Density of the back of the media on			0.5 ODU maximum
which the black mark is printed

*The 200M can be field-equipped with an optional reflective (black-mark) media sensor which replaces the factory-installed transmissive sensor. The black-mark media specifications shown for the 200M require that the optional reflective sensor kit be installed.

1-7