Operation |
Power On Self Test
A Power ON Self Test (POST) is performed each time the printer is turned ON. This test checks for proper initialization of various electronic circuits and establishes starting parameters as those stored in the printer’s memory. During this test sequence, the front panel lights will turn ON and OFF to ensure proper operation. At the end of this self test, only the POWER light will remain lit. If other lights are also lit, refer to the Troubleshooting Section.
Printer Self Tests
Introduction
These self tests produce sample labels and provide specific information that helps determine the operating conditions for the printer.
Each self test is enabled by holding in a specific Front Panel key or combination of keys while turning the Power Switch ON. Keep the key depressed until the Front Panel Lights turn ON.
When the Power On Self Test is completed, the selected self test automatically starts.
Notes: When performing self tests, all data interface cables connected to the rear of the printer must be removed.
When canceling a self test before its actual completion, always turn the printer Power OFF and then back ON to reset the printer.
When performing these self tests in the
Unless specifically stated, all tests print in
If your media is not wide enough, the test labels will only print out to the edge of the label. If your media is too short, the test label will continue printing on the next label.