Brady 200M, 260M Removing Used Ribbon, Initial Printer Power Up

M-Series User ’s Guide Installation

Removing Used Ribbon

To remove used ribbon, refer to Figure 2.7 and follow the steps below.

1.Pull the hook out slightly, then rotate the hook back-and-forth several times as shown and remove it from the spindle.

2.	Grasp the used rib-
	bon and remove it
	from the Ribbon
	Take-Up Spindle.
3.	Remove the
	empty core from
	the Ribbon Sup-
	ply Spindle.
4.	Follow the Rib-
	bon Loading pro-
	cedure on page
	2-4 to load the
		Figure 2.7 Removing Used Ribbon
	new ribbon.

Initial Printer Power Up

After you finish loading the ribbon and media, continue reading through Sections 3 and 4. Perform the following initial printer power-up steps as you come to them:

1.Power ON Self Test (POST)

2.Calibration

Subsequent power-ups will not necessarily require step 2 to be performed. See Sections 3 and 4 for further information.

2-11