Installation

M-Series User ’s G uide

 

 

Site Requirements

CAUTION: To ensure that the M-Series Printer has proper ventilation and cooling, do not place any padding or cushioning material on the back of or underneath the unit because this will restrict the air flow.

The M-Series Printer may be installed on any solid, level surface of sufficient size and strength to accommodate the unit. The area in which the printer will operate must meet the environmental conditions specified.

Since the Brady M-Series Printer was designed and is fabricated as an industrial-type unit, it will function satisfactorily in areas such as a warehouse or factory floor that conform to the specified environmental and electrical conditions.

Ribbon Loading

Refer to Figure 2.3 throughout this procedure.

Note: When placing the ribbon roll on the Ribbon Supply Spindle, make sure that the core is pushed up against the stop on the ribbon supply spindle and that the ribbon is aligned squarely with its core. If this is not done, the ribbon may not cover the inside edge of the printhead, exposing print elements to potentially damaging contact with the media.

Note: Do not load ribbon if the printer is to be used in the Direct

Thermal Mode.

CAUTION: Do not use ribbon that is narrower than the media. If the printhead is not protected by the smooth backing of the ribbon, excessive abrasion may cause premature printhead failure.

2-4